srw2024 downloading code using xmodem with putty

Here is the password/username combo im using (admin/blank admin/admin). Im trying to recover the password from my stacked switchs(doing procedure on master switch),im following a guide i have read in this forum('SRW248G4 V1.1 unable to reset password'), at console terminal have chosen 'password Recovery' it prompts the 'current password will be ignored' and then i hit 'Escape' the switch start loading de configuration, at this point i attempt to login from telnet or http but the login fails. The trouble is that in its original config, it had 1 port locked into its own VLAN for management with port security and an obscure RFC1918 IP address which I cannot recall for the life of me.Īt this point, I have no access to TCP/IP management so serial console is my last hope and is not working. I have done this and tried using multiple machines/ports/cables as well as several peices of software (minicom, PuTTy, hyperterminal) and none give me any output from the switch at all. The manual specifies: 38400 bps and 8-n-1 serial port settings using DB9F to DB9F cable. I have had the switch for about 2 years and recently moved.

Downloading code using XMODEM.Įwazen Bass Trombone Concerto Pdf there. It shows this message in my console: Exit from boot menu.

ADVERTISEMENT I have tried to update the firmware of my srw2016 but after this update my switch wouldn't start again.

Ford Cd 6006e Manual Srw2024 Downloading Code Using Xmodem With Putty. Since then I cannot get any image to boot and cannot install a new one despite many attempts with XMODEM.The switch is hardware version 1.1 with Boot image 'BOOT Software Version 1.0.0.03 Built 0 09:48:10' I've tried installing a new boot image via XMODEM: Similar Messages: View and Download mycom I125S instruction manual online. Switch Cisco SRW2024 Datasheet.Ĭisco Switches:: SRW2016 Software Upgrade / Recovery I recently acquired a used SRW2016 in perfect working order (I checked it) and then made the mistake of trying to update the software image. Appear Downloading code using XMODEM with. Using the Console Interface to configure HyperTerminal.

Srw2024 downloading code using xmodem with putty